Closet Builder
Design your whole closet
Draw your room, arrange modules on every wall, pick a paint — then send us the whole plan for one quote. Every size is checked against what our shop actually builds, so what you draw is what you get. Free local white-glove install included.
Room Type
A standard closet you reach into. Modules line the back wall.
Reach-In
Wardrobe
Walk-In
How to use the plan
Tap any blue number on the floor plan to edit it — width, depth, ceiling height and door width all live on the plan itself. Then set module height, depth and toe kick on the Sizing tab, and use the wall tabs to fill each wall. Switch the viewport between Plan , Wall and Room at any time.
Start over
Clears the room type, every dimension, both corners, every module on every wall and the finish — right back to a blank sheet.
Depth & height
Set once for the whole build — every wall, every module. Unlock either one to size modules individually, and the per-module control appears on each wall tab.
Toe Kick
How every module meets the floor — one choice across the whole build.
Corners
The back wall runs corner to corner. Each side run is set from the doorway end and fills back toward the corner, holding 1″ short of it — so the leftover lands here, where a scribed filler can cover it, and never as a ragged joint at the doorway. A top panel bridges from the back run across to wherever the side run starts, leaving open space underneath. The gap below follows the module depth, so the opening under the bridge starts out square. The back wall's corner stretch is open-front — there's no room in front of it for a door or a drawer.
Doors
One door style across the build. Modules under 24″ deep and the open-front corner stretch never take doors, whatever you pick here.
Drawers
Drawer fronts are picked on their own — a slab drawer bank under shaker doors is a common look.
Hardware finish
Berenson T-bar, one finish across every pull and knob.
Finish
One Sherwin-Williams paint across the whole build.
Pure White
Sherwin-Williams · SW 7005